I've successfully installed the new 1.6.0 Sierra RC1.pkg over an existing 1.5.2 dmg installation. Only issue was that the installer failed with being unable to load kexts, but following a reboot after first running, I was able to rerun the installer and complete the installation. Further reports as I turn anything else up. SIP disabled.
Cheers and thanks for all your hard work people! Much appreciated as ever.
1.6.0 Sierra RC1 - Successful install, required reboot
2 posts
• Page 1 of 1
1.6.0 Sierra RC1 - Successful install, required reboot
by FadingIntoBlue » Thu Jan 26, 2017 2:48 pm
- FadingIntoBlue
- Posts: 106
- Joined: Tue May 27, 2014 12:25 am
Re: 1.6.0 Sierra RC1 - Successful install, required reboot
by roemer » Fri Jan 27, 2017 4:30 pm
Similar experience here: After exporting my zfs pool, I was able to install 1.6.0rc1 without problems (10.12.2).
kext loaded correctly, but zpool wasn't able to find and import my pool again until I rebooted.
Then all was fine.
Many thanks to everyone involved!!
kext loaded correctly, but zpool wasn't able to find and import my pool again until I rebooted.
Then all was fine.
Many thanks to everyone involved!!
- roemer
- Posts: 73
- Joined: Sat Mar 15, 2014 2:32 pm
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 7 guests